strengthening the materials core of manufacturing enterprises
  • explore

Moldflow/C-MOLD Uncorrected Anisotropic Shrinkage

Test ID  

Properties needed to perform a Moldflow injection mold filling, packing, and shrink/warp simulation are generated. These include viscosity vs. shear rate at three temperatures (two in the processing range and one below), thermal properties, PVT data. Additionally, the following mechanical properties are derived from tests on specimens cut from injection molded plaques: tensile modulus in flow and cross-flow direction Poissonís Ratio in 12 and 23 directions, thermal expansion coefficient in flow and cross-flow directions and in-plane shear modulus. Data are fit to Moldflow models. This TestPak provides Gold-Gold-Gold .udb files.    
Included Tests  
# Test Id Test Name
1x D-020 PVT (Isothermal Heating)
1x M-017 In-Plane Shear Modulus (Plate Twist Method)
1x M-101 Poissonís Ratio and Tensile Modulus
1x M-102 Poissonís Ratio and Tensile Modulus (2-3 Direction)
3x R-011 Capillary Rheology (1 Temperature)
1x R-018 No-Flow Temperature
1x T-015 Specific Heat
1x T-103 Thermal Conductivity Scan
1x T-302 Thermal Expansion Coefficient by TMA (Anisotropic)
Moldflow .udb data files and accompanying material property data are provided. You can also create udb files as well as exports for other injection molding CAE using your Matereality CAE Modeler software.  
1 - kg of pellets [details]
15 - plaques (4 x 12in) [details]
There are two approaches to Moldflow Shrinkage/Warpage simulation. CRIMS and non-CRIMS. Either approach can be used for running Fill + Pack + Warp , a simulation that solves for filling, post-filling, shrinkage and warpage of the part. Recommended for plastics that are expected to show anisotropy, such as fiber-filled materials.